Enhance - Sony SNC-EMX Serie Manuel D'utilisation

Network camera
2.
Fixed exposure
Select the shutter time for fixed exposure. (The values available depend on the value set for
the ALC mode).
Day/Night
Auto - the camera switches the IR cut-off filter on and off depending on the scene illumination
level.
Monochrome - the IR cut-off filter is removed, giving full IR sensitivity.
Color - the camera always produces a color signal regardless of light levels.
Day-to-night switchover
(Only applicable to SNC-HMX cameras)
Adjust the slider to set the video level at which the camera in Auto mode switches from color
to monochrome operation (-15 to +15).
A low (negative) value means that the camera switches to monochrome at a lower light level. A
high (positive) value means that the camera switches to monochrome at a higher light level.
Night-to-day switchover
Adjust the slider to set the video level at which the camera in Auto mode switches from
monochrome to color operation (-15 to +15).
A low (negative) value means that the camera switches to color at a lower light level. A high
(positive) value means that the camera switches to color at a higher light level.
(The actual switch-over point might change automatically to avoid instable switching.)
Note:
To ensure stability when using IR illuminators, use the alarm interface for reliable Day/Night
switching.
IR function
(only for cameras with built-in IR illuminators)
Select the control setting for IR illumination:
–
–
–
Intensity level
Set the intensity of the IR beam (0 to 30).
4.3.5

Enhance

High dynamic range
(Only applicable to SNC-EMX50, EMX50R, and EMX52R)
Select:
Off: to disable HDR;
Auto: for automatic High Dynamic Range (HDR); depending on the scene the camera can
capture multiple exposures to increase Dynamic Range;
Extreme: as Auto, but with even higher Dynamic Range. Only use this in quiet scenes and low
light levels. Artifacts can occur depending on the light level and movement in the scene.
Sony Corporation
Select the Default shutter for automatic exposure. The default shutter improves the
motion performance in auto exposure mode.
Auto: the camera automatically switches the IR illumination.
On: the IR illumination is always on.
Off: the IR illumination is always off.
User manual
Configuration | en 71
2019-07 | V01 | DOC