Browser Connection; System Requirements; Establishing Connection; Password Network - Sony SNC-EMX Serie Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 142
Network camera
1

Browser connection

A computer with Microsoft Internet Explorer is used to receive live images, control the unit,
and replay stored sequences. The unit is configured over the network using the browser.
1.1

System requirements

Our recommendations are:
Note:
To see live images in your browser it might be necessary to download and install the MPEG-
ActiveX from the download store, available at https://downloadstore.boschsecurity.com.
1.2

Establishing connection

The unit must have a valid IP address to operate on your network and a compatible subnet
mask.
By default, DHCP is pre-set at the factory to On plus Link-Local so a DHCP server assigns an
IP address or, if no DHCP server is available, a link-local address (auto-IP) is assigned within
the range 169.254.1.0 to 169.254.254.255.
1.
2.
3.
Note:
If you cannot connect, the unit may have reached its maximum number of connections.
Depending on the device and network configuration, each unit can have up to 50 web browser
connections).
Password protection in camera
The device is password protected across various authorization levels. It is necessary to set a
password before accessing the device:
1.
2.
3.
4.
5.
6.
7.
1.3

Password Network

If a RADIUS server is used for network access control (802.1x authentication), the unit must
be configured first. To configure the unit, connect it directly to a computer using a network
cable and configure the two parameters, Identity and Password. Only after these have been
configured can communication with the unit via the network occur.
Sony Corporation
Computer with Dual core HyperThreading processor or better
Graphic card with performance that matches or is better than the resolution of the
camera
Windows 7 or later operating system
Network access
Internet Explorer version 11 or later
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions that appear.
Enter the user name.
Enter the password. The password should:
Be between 8 and 12 characters in length
Contain upper and lower case letters
Contain a minimum of one special character. These special characters are not allowed:
'@', '&', '<', '>', ':'
Contain a minimum of one digit.
Click OK. If the password is correct, the page is shown.
User manual
Browser connection | en
51
2019-07 | V01 | DOC

Publicité

Table des Matières
loading

Table des Matières