Display Stamping - Sony SNC-EMX Serie Manuel D'utilisation

60 en | Configuration
7.
8.
Time server address
The unit can receive the time signal from a time server using various time server protocols and
then use it to set the internal clock. The device polls the time signal automatically once every
minute.
Enter the IP address of a time server.
Overwrite by DHCP
Select this checkbox to have the DHCP server give the time server date.
Time server type
–
–
–
Click Set to apply the changes.
4.1.4

Display Stamping

Various overlays or stamps in the video image provide important supplementary information.
These overlays can be enabled individually and arranged on the image in a clear manner.
Camera name stamping
Select the position of the camera name overlay in the drop-down box. It can be displayed at
the Top, at the Bottom, or at a position of choice using the Custom option, or it can be set to
Off for no overlay information.
If the Custom option is selected, enter values in the X and Y position fields.
Logo
To place a logo on the image, select and upload an uncompressed .bmp file with a maximum
size of 128x128 pixels and 256 colors to the camera. Its position on the image can then be
selected.
Logo position
This option becomes available when the Camera name stamping option is enabled. Select:
–
–
–
–
Time stamping
Select the position of the time and date overlay in the drop-down box. It can be displayed at
the Top, at the Bottom, or at a position of choice using the Custom option, or it can be set to
Off for no overlay information.
If the Custom option is selected, enter values in the X and Y position fields.
Display milliseconds
If necessary, display milliseconds for Time stamping. This information can be useful for
recorded video images; however, it does increase the processor's computing time. Select Off
if displaying milliseconds is not needed.
2019-07 | V01 | DOC
If there are empty lines at the bottom of the table, for example after deletions, add new
data by marking the row and selecting values from the list boxes.
When finished, click OK to save and activate the table.
Select Time protocol if the server uses the RFC 868 protocol.
Select the protocol that is supported by the selected time server. It is recommended to
select the SNTP protocol protocol. This protocol provides high accuracy and is required
for special applications and future function extensions.
Select the TLS protocol if the server uses the RFC 5246 protocol.
Off : This option is disabled.
To the left of the name: The logo will be positioned to the left of the Camera name
stamping
To the right of the name: The logo will be positioned to the right of the Camera name
stamping
Logo only: The logo will be shown without the Camera name stamping.
User manual
Network camera
Sony Corporation