Date/Time - Sony SNC-EMX Serie Manuel D'utilisation

Network camera
3.
4.1.3

Date/Time

Date format
Select the required date format.
Device date/Device time
If there are multiple devices operating in your system or network, it is important to
synchronize their internal clocks. For example, it is only possible to identify and correctly
evaluate simultaneous recordings when all devices are operating on the same time.
1.
2.
Note:
It is important that the date/time is correct for recording. An incorrect date/time setting could
prevent correct recording.
Device time zone
Select the time zone in which the system is located.
Daylight saving time
The internal clock can switch automatically between normal and daylight saving time (DST).
The unit already contains the data for DST switch-overs for many years in advance. If the date,
time and zone have been set up correctly, a DST table is automatically created.
If you decide to create alternative daylight saving time dates by editing the table, note that
values occur in linked pairs (DST start and end dates).
First, check the time zone setting. If it is not correct, select the appropriate time zone and
click Set.
1.
2.
3.
4.
5.
6.
Sony Corporation
– user is the middle authorization level. At this level, it is possible to operate the
device and playback recordings, but configuration changes are not possible.
– service is the highest authorization level. Entering the correct password gives access
to all the functions, and allows all configuration settings to be changed.
Type, select either:
– Password for a new password.
Use a minimum of 6 and a maximum of 19 characters. The password must have
upper-case and lower-case letters, one or more numerical digits and one or more of
these special characters ! ? " # $ % ( ) { } [ ] * + - = . , ; ^ _ | ~ \
Special characters such as space @ : < > ' & are not valid.
In this case, enter the new password a second time to eliminate typing mistakes.
– Certificate for a certificate that the new user is authorized to use.
Enter the current date. Since the device time is controlled by the internal clock, it is not
necessary to enter the day of the week – it is added automatically.
Enter the current time or click Sync to PC to apply the system time from your computer
to the device.
Click Details to edit the DST table.
Select the region or the city which is closest to the system's location from the list box
below the table.
Click Generate to fill the table with the preset values from the unit.
Click one of the entries in the table to make changes. The entry is highlighted.
Click Delete to remove the entry from the table.
Choose other values from the list boxes under the table, to change the selected entry.
Changes are immediate.
User manual
Configuration | en 59
2019-07 | V01 | DOC