Camera; Installer Menu - Sony SNC-EMX Serie Manuel D'utilisation

64 en | Configuration
4.3

Camera

4.3.1

Installer Menu

Application variant
(Only applicable to SNC-HMX cameras)
The camera has a choice of application variants that set up the camera for optimum
performance in a specific environment. Select the application variant best suited to your
installation.
The application variant must be selected before any other changes are made, as the camera
reboots automatically and resets the factory defaults when the application variant is changed.
Sensor mode
Select the sensor mode for the camera.
Note: Shutter times, frame rates, and the analog output (if present) are affected by this value.
Image rotation
(Only applicable to SNC-EMX cameras)
The integrated gyro/accelerometer sensor detects the optimal image orientation and allows
the user to select it by clicking Use proposed rotation.
Select the required angle (0°, 90°, 180° or 270°) to output the correct image orientation.
Mirror image
(Only applicable to SNC-EMX cameras)
Select On to output a mirror image of the camera picture.
Coding standard
(Only applicable to SNC-EMX cameras)
Select the coding standard, H.264, H.265, or H.265 (no B-frames). (H.265 (no B-frames) is only
applicable to SNC-EMX30, EMX30R and EMX32R.)
Camera LED
Disable the Camera LED on the camera to switch it off.
Button 'MENU'
(Only applicable to SNC-EMX cameras)
Select Disabled to prevent access to the install wizard via the menu button on the camera
itself.
Analog output
(Only applicable to SNC-EMX cameras)
Select an aspect ratio format to activate the analog output of the camera.
Reboot device
Click Reboot to restart the camera.
Factory defaults
Click Defaults to restore the factory defaults for the camera. A confirmation screen appears.
Allow several seconds for the camera to optimize the picture after a reset.
Lens Wizard...
(Only applicable to SNC-EMX cameras)
Click Lens Wizard... to open a separate window which can be used to focus the camera lens.
This page enables you to focus the lens on a particular area.
In the preview window, use the mouse to change the size and position of the shaded box that
defines the focus area.
Default
(only for cameras with motorized focus adjustment)
2019-07 | V01 | DOC User manual
Network camera
Sony Corporation