Hach LS 120 Manuel De L'utilisateur page 3

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Table of Contents
1 Specifications
on page 3
2 General information
3 Installation
on page 5
Section 1 Specifications
Specifications are subject to change without notice.
Specification
Dimensions
Power supply
Instrument
Plug-in power supply unit LZV563
Weight
Enclosure
Overvoltage category
Pollution degree
Operating requirements
Storage requirements
Altitude
Environmental conditions Indoor use
Compliance
Warranty
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
on page 3
Details
190 x 112 x 240 mm (7.48 x 4.41 x 9.45 in.)
100–240 VAC ± 10%; 50–60 Hz; 0.75 A
15 VDC; 30 VA
2.9 kg (6.39 lb), inclusive plug-in power supply unit
IP20
II
2
10 to 40 °C (50 to 104 °F); maximum 80% relative humidity (non-
condensing)
-40 to 60 °C (-40 to140 °F); maximum 80% relative humidity (non-
condensing)
2000 m (6562 ft) maximum
CE
EU: 2 years (US: 1 year)
4 Operation
on page 5
5 Maintenance
on page 6
English 3

Publicité

Table des Matières
loading

Table des Matières