To Set Redial Interval; Setting Dial Tone Detection - HP LaserJet MFP Analog Fax Accessory 300 Guide

1
2
3
4
5

To set redial interval

The redial interval setting selects the number of minutes between
retries if the number dialed is busy or not answering.
1
2
3
4
5

Setting dial tone detection

The detect dial tone setting determines whether the fax checks for a
dial tone before sending a fax.
To enable or disable dial tone detection, perform the following steps.
1
2
3
4
5
40 Chapter 3 Configuration
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Scroll down and touch REDIAL ON NO ANSWER to display the
setting screen.
Use the up and down arrows to select the number (default=0),
and then touch OK.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Scroll down and touch REDIAL INTERVAL to display
setting screen.
Use the up and down arrows to select the number (1 through
5 minutes; default=5), and then touch OK.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Scroll down and touch DETECT DIAL TONE to display the detect
dial tone settings.
Touch ON (default) to enable dial tone detection, or touch OFF to
disable dial tone detection.
ENWW