Setting The Modem Volume; Setting The Ringer Volume; Setting Error Correction Mode - HP LaserJet MFP Analog Fax Accessory 300 Guide

In addition to configuring a single MFP, you can also configure
multiple devices. For more information on the HP MFP Digital
Sending Software Configuration Utility, see the HP MFP Digital
Sending Software User Guide or the HP MFP Digital Sending
Software Support Guide.
Depending on the capabilities and settings of your fax method, some
Note
of these options may not be available or configurable.

Setting the modem volume

To set the modem volume, perform the following steps.
1
2
3
4
5

Setting the ringer volume

To set the ringer volume, perform the following steps.
1
2
3
4
5

Setting error correction mode

Normally, the fax accessory monitors the signals on the telephone
line while it is sending or receiving a fax. If the fax accessory detects
an error during the transmission and the error correction setting is on,
the fax accessory can request that the error portion of the fax be sent
again.
36 Chapter 3 Configuration
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Touch FAX SETUP OPTIONAL to display the optional
settings menu.
Touch MODEM VOLUME to display the volume settings.
Touch OFF, MEDIUM (default), or LOUD to set the volume.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Touch FAX SETUP OPTIONAL to display the optional
setup items.
Touch RINGER VOLUME to display the settings.
Touch OFF, MEDIUM (default), or LOUD to change the volume.
ENWW