To Send A Fax Using Speed Dial - HP LaserJet MFP Analog Fax Accessory 300 Guide

If needed, enter a comma (,) to provide a two second pause after a
Note
prefix number (such as a "9" or "0" ) to allow the internal phone system
time to access an outside line before the remainder of the number is
dialed.
8
If you have made any changes to the settings on the Settings screen
Note
(such as changing notification or 1-sided to 2-sided), a Processing Job
screen displays asking "Would you like to keep your current settings?".
If you press Yes, the MFP returns you to the Fax screen and the
settings you made are retained. This allows you to send another fax
using the same settings. If you press No, the settings are cleared
(returned to their default values) and the MFP home screen displays.

To send a fax using speed dial

Prior to sending a fax using speed dial, you must create a speed dial.
Note
To create a speed dial, see "Creating and deleting speed dial lists" on
page 27.
To send a fax using the speed dial, complete the following steps.
1
2
3
20 Chapter 2 Faxing
Touch Start to send the fax. You can either touch the Start
button on the touch screen or press the green Start button on the
control panel.
Place the document in the automatic document feeder (ADF) or
on the scanner glass.
From the main screen, touch the FAX icon. You may be
prompted to type a user name and password.
Touch Settings. Verify that the Describe Original settings match
those of your original. These settings include:
• Page size (such as letter or A4)
• 1-sided or 2-sided printing
• Page content (text, mixed text and graphics, or graphics and
photos) Sending graphics and photos in text mode results in
lower quality images.
• Orientation (portrait or landscape)
• Job Mode combines multiple scans into a single job.
If the settings do not match, complete the following steps.
a Touch Describe Original to display the Original Setting
screen.
b Make any required changes to match your original.
ENWW