Troubleshooting - Philips 2100 Serie Mode D'emploi

Troubleshooting

Problem
There is water under the
machine.
The machine does not switch on. The machine is
- The warning light flashes quickly. There is no water in the internal circuit.
Turn the control dial to the hot water icon and let hot water come out of
the machine until the water flows continuously. See chapter 'Preparing
for use' section 'Heating up the machine'. Follow steps 3 and 4.
- The warning light flashes slowly. The brewing unit is not correctly
inserted, the coffee grounds container is not inserted, the service door is
open or the control dial is not in the correct position. Make sure the
brewing unit and coffee grounds container are inserted correctly, the
service door is closed and the control dial is in the correct position. If you
cannot take out the brewing unit or place it back, switch the machine off
and back on again.
- All the lights flash slowly and simultaneously. The machine is out of
order. Switch off the machine for 30 seconds, then switch it back on.Try
this two or three times. If the machine does not reset, contact the Philips
Consumer Care Centre.
This chapter summarises the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Philips Consumer Care Centre in your
country.
Cause
The drip tray is too full
and overflowed.
The machine is not
placed on a horizontal
surface.
disconnected.
Solution
Empty the drip tray when the drip tray
full indicator pops up through the drip
tray. Always empty the drip tray before
you start descaling the machine.
Place the machine on a horizontal
surface so that the drip tray full indicator
works properly.
Make sure the small plug is inserted into
the socket. Plug in and switch on the
machine.
English
27