Filling The Coffee Bean Container; Heating Up The Machine - Philips 2100 Serie Mode D'emploi

English
10

Filling the coffee bean container

Heating up the machine

1 Fill the coffee bean container with espresso beans.
Note: Only use espresso beans. Never use ground coffee, unroasted
coffee beans or caramelised coffee beans, as this may cause damage to
the machine.
2 Put the lid on the coffee bean container.
During the initial heat-up process, fresh water flows through the internal
circuit to heat up the machine. This takes a few seconds.
1 Place a big cup under the hot water/steam wand and the coffee spout.
Make sure the control dial points to one of the coffee bean icons.
2 Press the on/off button.
3 When the warning light flashes quickly, turn the control dial to the hot
water icon and wait a few seconds.
-
The warning light goes out and some water comes out of the hot
water/steam wand or automatic milk frother.
4 After a few seconds, when hot water stops coming out of the hot
water/steam wand and the warning light flashes slowly, turn the control
dial back to the single bean icon.
-
The machine is heating up and the on/off button flashes slowly.
-
When the machine has heated up, it performs an automatic rinsing
cycle to clean the internal circuit with fresh water. Water flows from
the coffee spout.
-
When the on/off button lights up continuously, the machine is ready
for the manual rinsing cycle.
Note:You can stop the automatic rinsing cycle by pressing the espresso
or the cappuccino button.
Note:The automatic rinsing cycle also takes place 60 minutes after the
appliance switches to standby mode or switches off.