Installing The Intenza+ Water Filter; Using The Machine - Philips 2100 Serie Mode D'emploi

Installing the Intenza+ water filter

Using the machine

We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Guarantee and support', section 'Ordering
maintenance products'.
1 Remove the small white filter from the water tank and store it in a dry
place.
Note: Please keep the small white filter for future use. You will need it for
the descaling process.
2 Remove the filter from its packaging and immerse it in cold water with the
opening pointing upwards. Press the sides of the filter gently to let out
the air bubbles.
3 Turn the knob of the filter to the setting that corresponds to the water
hardness of the area you live in.
a Very soft water/ soft water
b Hard water (default)
c Very hard water
Note: You can test the water hardness with a water hardness test strip.
4 Place the filter in the empty water tank. Press it down until it cannot
move any further.
5 Fill the water tank with fresh water up to the MAX indication and slide it
into the machine.
6 Let the machine brew hot water until the water tank is empty (see
chapter 'Using the machine', section 'Hot water').
7 Refill the water tank with fresh water up to the MAX indication and slide it
back into the machine.
-
The on/off button lights up continuously.
The machine is ready for use.
To guarantee perfect espresso, the machine regularly rinses its inner circuit
with water. This automatic rinsing cycle takes place 60 minutes after the
appliance switches to standby mode or switches off. During the automatic
English
11