Glp Print; Reset - OHAUS Adventurer Pro AV53 Guide De L'utilisateur

EN-24
Project ID
Used to enter a Project ID up to 10 characters.
Entering a User ID or Project ID
Enter the user or Project ID one character at a
time. The character to be entered is highlighted
by a blinking cursor (underscore). Press the
No button repeatedly to scroll through the list
of available characters. ((space), -, 0 through
9, A through Z). Press the Yes button to select
the displayed character and move the cursor
one position to the right. After the tenth
character is entered, the ten character ID will
blink. Press the No button to change the
displayed ID or the Yes button to accept the ID
and proceed to the next menu item.
Time
Type
Set the type to 12 hours or 24 hours.
Set
Set the current time using the format selected
in the type menu item.
Adjust
Enter an adjustment value from -60 to + 60
seconds per day.
Date
Set the date type: M/D/Y, D/M/Y, Y/M/D,
M/Y/D, Y/D/M, D/Y/M and the actual date.
End GLP Data
Press the Yes button to advance to the GLP Print
submenu. Press the No button to return to User
ID.

3.7.9 GLP Print

Select GLP items to be printed by setting them
to On.
GLP PRINT
Time On/Off
Balance ID On/Off
User ID On/Off
Project ID On/Off
Difference On/Off
Name On/Off
End GLP Prt
End GLP Print
Press the Yes button to advance to the reset
submenu. Press the No button to return to Time.
3.7.10

Reset

RESET
Setup RESET?
Readout RESET?
Mode RESET?
Unit RESET?
Print-1 RESET?
Print-2 RESET?
RS232-1 RESET?
RS232-2 RESET?
GLP Data RESET?
GLP Print RESET?
Lockout RESET?
Global RESET?
End Reset
Setup
Select Yes to return all Setup menu items to
their factory settings.
Readout
Select Yes to return all Readout menu items to
their factory settings.
Mode
Select Yes to return all Mode menu items to
their factory settings.
Adventurer Pro