Application Modes; Weighing; Parts Counting - OHAUS Adventurer Pro AV53 Guide De L'utilisateur

EN-12

3.5 Application Modes

The Adventurer Pro balance incorporates Weighing, Parts Counting, Percent Weighing, Check
Weighing, Animal Weighing and Totalize application modes. The default setting has the weighing
mode turned on and all other application modes turned off. Before using any other application
modes, they must be turned on in the Mode menu.

3.5.1 Weighing

Use this mode to determine the weight of items in the selected unit of measure. The Adventurer
Pro is shipped with grams enabled. Before using any other units of measure, they must be
turned on in the Unit menu.
USE
Zero the balance
Place objects to be weighed on the pan.
Example shows a 200 gram weight on a 200
gram balance.

3.5.2 Parts Counting

Enter this mode to count samples of uniform weight. Refer to paragraph 3.3.4 to enable Parts
Counting.
USE
The primary display shows COUNT and the
secondary display shows CLEAR APW?
(blinking) if an APW is stored in memory. Press
No to use the stored APW and begin parts
counting. If CLEAR APW? is chosen or if no
APW is stored in memory, an APW must be
established.
Establishing an Average Piece Weight (APW)
The current weight is shown on the primary
display and the default sample size is shown
on the secondary display.
To change the sample size, Press and hold
the No button to increment the sample size
through the range of 1 to 100. Release the
button when the desired sample size appears
on the secondary display.
Adventurer Pro