Connect Power Cords - HP LaserJet 9040mfp Guide De Mise En Route

Step 11. Connect power cords
This section describes how to connect the power cord.
1
2
3
3
22 Product Setup
CAUTION
Do not connect the product power cord to the power-cord connector on
Tray 4. That connector is designed to connect paper output devices
such as the multifunction finisher to Tray 4.
To prevent damage to the product, use only the power cords that came
with the product.
1 Connect the power cord(s) to the product power cord connector and
to the Tray 4 connector. Then connect the power cords to an
adequate alternating current (AC) outlet.
Note
For best performance, a dedicated 110V, 15-amp outlet (or a 220V,
8-amp outlet) is recommended.
2 Press the power button to turn the product on (button in). After the
product warms up, a prompt will appear asking you to configure
your control panel display language. (See
panel display language.)
3 Check that the light on the output device is solid green. Also make
sure that the light on Tray 4 is solid green. If the light is amber,
flashing, or off, see the use guide for more information.
Configure the control
ENWW