Change From An Ethernet Connection; Connect The Hp Officejet/Officejet Pro Device Using An Ad Hoc Wireless Network Connection; Method 2 (Windows Only) - HP Officejet 6000 Serie Guide De Mise En Route

Change from an Ethernet
connection
Use the following instructions to change from an
Ethernet connection to a wireless connection.
NOTE: For Ethernet-enabled HP devices only.
1. Open the embedded Web server (EWS). For more
information on the EWS, see the electronic User
Guide available on your computer after you install
the software.
Connect the HP Officejet/Officejet Pro device using an
ad hoc wireless network connection
Method 1
1. Turn on wireless in your computer and in the
HP device.
2. On your computer, connect to the network name
(SSID) "hpsetup". (This network name is the default,
ad hoc network created by the HP device.)
If your HP device was previously configured for a
different network, you can restore the network defaults
to enable the device to use "hpsetup". To restore the
network defaults complete the following steps:
HP Officejet 6000 On the HP device's control panel,
Printer Series press and hold (
button, press (
three times, and then release
( ) Wireless button.
The Power light blinks for a few
seconds.
HP Officejet 6500 a. On the HP device's control
All-in-One Series panel, press the Setup (
button.
b. Select Network Setup, and
then select Restore Network
Defaults.
HP Officejet Pro On the HP device's control panel,
8000 Printer press and hold (
Series button, press (
three times, and then release
( ) Wireless button.
The Power light blinks for a few
seconds.
) Wireless
) Resume button
)
) Wireless
) Resume button

Connect the HP Officejet/Officejet Pro device using an ad hoc wireless network connection

2. Click the Networking tab, and then click Wireless
(802.11) in the left pane.
3. On the Wireless Setup tab, press Start Wizard.
4. Follow the onscreen instructions to change from an
Ethernet connection to a wireless connection.
5. After you finish changing the settings, disconnect the
Ethernet cable.

Method 2 (Windows only)

1. Make sure your computer has an ad hoc network
profile. For more information, see the documentation
available with your operating system.
2. Follow the instructions in "Install software for your
HP Officejet/Officejet Pro device" on page 5 and
select the network that corresponds to the ad hoc
network profile for your computer.
11