Remove Internal Packaging - HP LaserJet 9040mfp Guide De Mise En Route

Step 4. Remove internal packaging
CAUTION The product contains orange shipping tape and internal packaging to prevent damage during
shipping. You must remove all shipping materials and internal packaging in order for the product
to function correctly.
1
2
3
4
5
6
7
Note Save all packing material. You might need it to repack the product at another time.
14 Product Setup
Remove all orange packing material from the exterior of the product and remove any
cardboard or styrofoam material that is not orange.
Remove all orange packing material from the output bin and the protective film from the
control panel display.
Open the left door and pull straight back on the shipping tape to remove the two fuser
shipping locks (as shown by the diagram on the product). Make sure that the fuser levers are
in the lock position.
Open the trays, remove any orange packing material, and close the trays.
Open the front door and remove the orange packing tape at the front transfer roller area and
on the lock lever for the print cartridge. Close the front door.
Open the ADF door and remove all of the orange packing material and any orange tape.
Remove all orange packing material and any orange tape from the flatbed glass.
ENWW