Remove Internal Packaging - HP LaserJet 9000mfp Démarrage Rapide

Step 3 Remove internal packaging
1
WARNING! This product weighs approximately 143.2 kg (315 lb). HP recommends
that the product be rolled on its wheels rather than be lifted.
2
3
4
5
6
7
Note Save all packing material. You might need it to repack the product at
another time.
10 Product Setup
To remove the product from the box, follow the instructions
printed on the box.
Remove the orange shipping lock from the exterior of the product,
and remove any cardboard or styrofoam material that is not
orange.
Remove the protective film from the control panel graphical
display. (See Step 4, "Identify product parts.")
Open the left door and remove the two packing fuser assembly
spacers. Orange tape connects fuser assembly spacers to the
outside of the left door. Remove the orange tape that runs from
the fuser assembly shipping locks to the outside of the door.
Close the door after removing the fuser assembly spacers and
the tape.
Open each tray, remove the orange shipping locks and any other
orange packing material, and then close the trays.
Remove all orange packing material and any orange tape from
the automatic document feeder (ADF) door.
Remove all orange packing material and any orange tape from
the glass.
ENWW