Operation Guide - SPORTSTECH CX640 Manuel De L'utilisateur

9. OPERATION GUIDE

1. Sleep Mode:
The computer will enter the sleep mode when there is no signal input and no keys be pressed after
4 minutes. You can press any key to wake up the computer.
2. Error Message:
E1 (ERROR 1):
Normal state: During workout, when the monitor did not get the count signal from the gear motor
more than 4 seconds and check under successive 3 times then the LCD will show E1.
Power on state: The gear motor will return to zero automatically, when the signal of motor cannot
be detected for more than 4 seconds then the gear motor's driver will be cut off immediately and
show the E1 on the LCD display. All the other digital and function mark are blank, and the output
signals are cut off also.
E2 (ERROR 2):
When the monitor read the memory data, if the I.D. code is not correct or the memory IC damages
then the monitor will show E2 immediately at power on.
E3 (ERROR 3):
After 4 seconds by start mode, the computer detects the faulty motor did not leave the zero point
then the LCD bar displays "E3".
57