Handlebar - SPORTSTECH CX640 Manuel De L'utilisateur

Handlebar:

Remove two M8x15 Bolts (28) and two Ø8xØ16 x1.5Curve Washers (60) from the Front Post (9).
Insert the Hand Pulse Sensor Wires (43) from the Handlebar (10) into the hole on the Front Post (9)
and then pull them out from the top end of the Front Post (9).
Attach the Handlebar (10) onto the Front Post (9) with two M8x15 Bolts (28) and two Ø8xØ16x1.5
Curve Washers (60) that were removed with the S6 Allen Wrench provided
Computer and BollInstallation:
Remove four M5x15 Bolts (58) from the back of the Computer (61).
Connect the Sensor Wire I (20) and Hand Pulse Sensor Wires (43) to the wires that come from the
Computer (61) and then attach the Computer (61) onto the top end of the Front Post (9) with four
M5x15 Bolts (58) that were removed.
Remove two M5x15 Bolt (58) and Ø5 Washer(74) from the handlebar Post (9),attach the Bottle
Holder (73) to the Handlebar Post (9) with two M5x15 Bolt (58) and Ø5 Washer(74) that were
removed.
48