3B-390977NU – 10/18
14.5 STOPPING THE CLEANING CYCLE
To stop a cleaning cycle that is running:
- Press the stop button:
If this action is not validated the cycle is paused but not stopped (It will restart after a few seconds if no further action is taken).
Pressing the button for a second time will restart the cleaning cycle
- Confirm by validating using "End?".
Depending on the progress of the cleaning cycle, it will stop immediately or go directly to rinsing before stopping.
Cycle in progress
14.6 RAPID RINSING
14.7 REPLACEMENT OF THE CHEMICAL CONTAINER (Priming Cleaner function
The cleaning chemical supply hose is labelled which corresponds to the container.
"STOP" stops the
è
"End?" Stops the cleaning cycle.
è
Action in the event the cycle stops
Preheating
Stops immediately
Prewash
Wash
Automatically switches to rinse mode then stops
Rinse
Finishes rinsing then stop
Warning: If the message « i81 » appears during a washing cycle, check the water valve and pressure.
It is imperative that the cavity is rinsed profusely before cooking.
Rapid rinse function using only water (no chemical) for example between two
è
different types of cooking
Never use descaling product in the automatic cleaning system. This could seriously damage the ovens
hydraulic circuits.
Note: Refer to the "Recommendations" chapter when handling or using these chemicals, if in any doubt refer to the
products safety sheet
Changing the detergent containers
Use the « Priming Cleaner» function when changing the chemical container if the
supply tube is empty.
è
For example when you start the unit for the first time.
The oven will prime the product then rinse for several minutes
Page 9
cycle.
:
)
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
- 9 -
EN