Checklist For Installation; Removing Packaging; Left Packaging Bracket Removal; Right Packaging Bracket Removal - Thermador Professional Serie Guide D'installation

Checklist for Installation

Use this checklist to verify that you have completed each
step of the installation process. This can help you avoid
common mistakes.
Always read and follow the complete installation
instructions contained in this manual.
Refer to detailed instructions for each step in the
sections following this checklist.
Before installing the oven, be sure to verify the cabinet
1.
dimensions are correct for your unit and that the
required electrical connections are present. Make sure
the electrical conduit provided on the unit is able to
reach to the point of connection.
Section: Dimensions and Cabinet Requirements
Move the oven unit into place in front of the cabinet
2.
opening.
Section: Removing Packaging
Remove packaging materials, leaving the bottom
3.
packaging on the unit to avoid damaging flooring.
Section: Removing Packaging

Removing Packaging

NOTICE: To prevent damage to your floor keep the unit
in its packaging base until ready to be placed in the
cabinet opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
Cut straps on outside of box.
1.
Remove cardboard box.
2.
Remove all top and side cardboard, foam and wood
3.
packaging.
Place oven (leaving it on the shipping base) in front of
4.
the cabinet where it is to be installed.
Remove all accessories, racks, packing materials and
5.
literature from the oven cavity. Check both cavities for
double ovens.
Unscrew unit from packaging brackets as shown. The
6.
screws near the base mounting bracket are all T20
size. Only the one screw that goes through the slotted
hole in the mounting bracket on the left and right sides
of the unit needs to be removed in order to lift the unit
from the mounting base.
Remove the T20 (star head) screws holding the unit to
4.
the base of the carton.
Section: Removing Packaging
Perform Electrical Installation.
5.
Section: Electrical Installation
Remove the oven door or doors (bottom hinge only).
6.
Section: Oven Installation, "Removing the Oven Door"
Team lift the unit directly into the cabinet cutout.
7.
Section: Oven Installation, "Placing the Oven into the
Cabinet Opening"
Slide the unit all the way into place.
8.
Section: Oven Installation, "Placing the Oven into the
Cabinet Opening"
Fasten the oven unit to the cabinetry opening with the
9.
screws supplied.
Section: Oven Installation, "Placing the Oven into the
Cabinet Opening"
Reinstall the oven door(s).
10.
Section: Oven Installation, "Placing the Oven into the
Cabinet Opening"

Left Packaging Bracket Removal

Right Packaging Bracket Removal

7