Setting The Alarm Clock - Sangean WFR-20 Mode D'emploi

Setting the alarm clock

Your radio has four separate alarms which can be set to wake you to
either a radio station or a buzzer alarm. Each alarm can be set to sound
either once, everyday, weekly, weekdays or at weekends. In the event
of a power interruption your radio has built in memory chip that will
retain your alarm settings.
Note:
If no buttons are pressed for 10 seconds the radio will exit the alarm
setup. If you make a mistake at any point, use the Back option to go
back to the previous screen.
1. Usethe Select control to switch on your radio and to access
the menus. If needed, use the Back option to access the main
Mode menu.
2. Rotate the Select control until the 'Alarm clock' is highlighted on
the display. Press the Select control to enter the alarm settings.
3. Rotate the Select control until 'Set Alarms' is highlighted on the
display then press the Select control. The display willshow the
status of alarms 1-4. It will also offer a 'Disable All' option.
4. Rotate the Select control until the desired alarm 1 - 4 is highlighted
on the display. Alarms which are not highlighted show the time of the
next alarm (if any) and the day of the week on which they will occur.
The currently highlighted entry will scroll through the full alarm details
including whether the alarm is daily, weekly, etc. and the details of
the alarm type (buzzer or radio station name).
5. To change the setting for the highlighted alarm press the Select
control. The alarm hour will be highlighted. The 12 hour or 24 hour
clock format will be used according to the currently selected clock
format option.
47
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:14
GB
44