Upgrade Firmware - Sangean WFR-20 Mode D'emploi

Upgrade firmware

From time to time, new software features for your radio may be
developed. For example, a new audio decoder may be added to
allow an alternative audio format to be supported. You radio has
therefore been designed to allow its internal software to be upgraded
using your Internet connection. The upgrade mechanism is accessible
via the Configure menu.
Upgrading the software will remove all network settings, radio station
presets and alarm settings from your radio. Do not attempt this
procedure unless you have a good Internet connection and a reliable
mains power supply. If you connect to your router using a Wi-Fi
connection, make sure that this is also reliable before proceeding.
The Upgrade Firmware option allows your radio to download new
internal software from the Reciva portal on the Internet. If there is new
software available, then the radio will ask whether you want to download
it or not. Selecting No or using the Back optionwill cancel the operation.
A software upgrade may take several minutes.
IMPORTANT:
Do not switch off the power to the radio until the upgrade operation is
complete and the radio has restarted, otherwise the radio may become
permanently damaged.
Once the software upgrade is completed your radio will restart.
If you use a Wi-Fi connection, you will need to re-enter all network
settings in order to be able reconnect to your network. A firmware
update also erases all radio station presets, alarm settings,
and configuration options.
55
58 2007/10/1, ¤U¤È 05:14
20070929_WFR-20_381R101-A_GB.p65