Sangean WFR-20 Mode D'emploi page 14

Connecting to a wireless network cont.
7. When the ESSID for the access point you want to connect to is
highlighted on the screen, press the Select control.
8. If your network is not configured to need an encryption code,
the screen should say 'Connecting to network', then 'Network OK'.
If this is the case then you have successfully connected your radio
to your network, so please proceed to the section 'After you have
connected to your network' on the next page.
9. If the screen displays either 'Enter WEP key' or 'Enter WPA key',
it is because the network is using one of the encryption systems:
Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA).
You therefore need to enter the correct WEP or WPA key into the
radio to allow it to communicate with your network.
If you do not have the WEP or WPA key, then you should obtain it
from the person who set your network. Some Wi-Fi routers may
come with a key already set up by the supplier, in which case you
should refer to the user documentation provided with it.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F).
Some Wi-Fi access points can also use pass-phrases for WEP but
these do not conform to a defined standard and are not supported.
WPA keys are usually set up using a pass-phrase of between 8 and
63 characters. Your Internet radio can accept pass-phrases for
WPA keys.
If the WEP or WPA key was previously entered and the radio has not
had a factory reset the display will show 'Using saved key' and
should then connect to the network.
10. After 3 seconds, the display goes into the key entry mode. To enter
the key, use the knob to select each character of the key in turn,
pressing the Select control after each character. Remember, WEP
keys only use the numbers 0 - 9 and letters A - F. WPA keys are
sensitive to upper and lower case characters so you must enter
them exactly.
13
16
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:12