Setting The Clock - Sangean WFR-20 Mode D'emploi

Setting the clock

Normally the WFR-20 Internet radio will set its clock automatically
to UK time after a connection to the Internet has been established.
Should you need to set the time manually, please follow this procedure.
1. Use the Select control to switch on your radio and to access
the menus. If needed, use the Back option to access the main
Mode menu.
2. Rotate the Select control until the display says 'Configure'.
Press the Select control to enter the configure menu.
3. Rotate the Select control until 'Clock Setup' appears on the display.
Press the Select control to enter the clock setup menu.
4. Rotate the Select control until 'Set Time/Date' is highlighted on
the display. Press the Select control to highlight the hour digits
on the display.
5. Rotate the Select control to select the hour. Press the Select control
to highlight the minute digits on the display.
6. Rotate the Select control until the correct date is highlighted on
the display. Press the Select control enter the date and to highlight
the month on the display.
7. Rotate the Select control to select the correct month.
Press the Select control enter the month and to highlight the year
on the display.
8. Rotate the Select control to select the year. Press the Select control
to confirm the clock setting. The display will show 'Time and Date
Set' and will then return to the radio station display.
41
44
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:14