Backlight - Sangean WFR-20 Mode D'emploi

Backlight

This option allows you to alter the radio's display backlight settings
to suit your needs. Separate settings are available for Active mode
(while using the menu system), Inactive mode (when listening),
and Standby mode (when the radio is off with just the clock
display showing).
1. Usethe Select control to switch on your radio and to access
the menus. If needed, use the Back option to access the main
Mode menu.
2. Rotate the Select control until 'Configure' is highlighted on the
display. Press the Select control to enter the Configure menu.
3. Rotate the Select control until 'Backlight' is highlighted on the
display. Press the Select control to enter the Backlight menu.
4. The backlight setting can be adjusted for'Active','Inactive'and'Standby'
modes. Rotate the Select control to highlight the desired backlight
option then press the Select control.
5. The radio will now display the setting for the selected backlight
option. You can alter this value by rotating the Select control to
increase or decrease it according to your needs.
6. When the desired value is reached, press the Select control to store
the setting. If the value is not modi.ed or stored after .ve seconds,
the radio exit the Backlight menu and will return to its previous
display.
49
52
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:14