Connecting To A Wireless Network - Sangean WFR-20 Mode D'emploi

Connecting to a wireless network

1. When the display says 'Scan for networks', press the Select control.
The radio will now scan for all available wireless networks and will
show 'Scanning'.
2. If the radio cannot find a network then the display will say
'No Wireless Networks Found'. If this happens then you will have to
get your wireless access point working - please see the instructions
supplied with it.
3. When the radio finds your wireless network, it displays the Network
Name (ESSID) for the access point on the screen. This is a name
that is allocated to the access point by the person who set up the
network - for example: 'My Home Network'.
4. It is possible, and in some locations highly likely, that your radio will
find more than one wireless access point, in which case you should
choose which one you need to connect to.
5. Rotate the Select control to see the ESSID for each access point that
the radio has found. If your network is shown proceed to step 7 on
the next page.
6. If your network is not found, it is possible that it is configured such
that the ESSID is not broadcast (sometimes referred to as hidden).
If this is the case then use the Back option and then select
'Enter network name'. This procedure is described in the
'Network Configuration Menu', 'Entering the network name manually'.
If you know that your network name is not hidden, and it was not
found, then either try re-scanning, or refer to 'Troubleshooting'.
If you make a mistake at any point, use the Back option to go back
to the previous screen.
15
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:12
GB
12