Connecting Your Radio To Your Computer Network - Sangean WFR-20 Mode D'emploi

Connecting your radio to your computer network

1. Place your radio on a flat surface and plug the mains lead into the
Mains input socket located on the rear of your radio (marked 'AC in')
ensuring that the plug is pushed fully into the socket.
2. If planning to use a wired network connect the Ethernet cable into
the LAN socket at the back of the radio. If a wired connection
is present then the radio will use this in preference to a wireless
connection.
3. Plug the other end of the mains lead into a wall socket and switch
on the wall socket.
IMPORTANT:
The mains plug is used as the means of connecting the radio to the
mains supply. The mains socket used for the radio must remain
accessible during normal use. In order to disconnect the radio from
the mains completely, the mains plug should be removed from the
mains socket outlet completely.
4. The display on the front of the radio will light up and say:
'Welcome to Internet Radio'. If you are using a wired Ethernet
connection to your router, the radio should connect, and download a
radio station list update. It will then go to the main mode menu,
'After you have connected to your network'.
If you are not using a wired connection, or if the wired connection is
not working, after a few seconds the display will change to show
'Scan for networks'.
There are two indicator lights incorporated into the LAN connector.
If you have problems with your wired connection, they may help you
to identify the possible cause of the problem.
Green ON = Link established, Flashing = Data transfer
Yellow ON = 100M bps link, OFF = 10M bps link
11
14
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:12