Setting The Alarm Time - Sangean ProTravel PT80 Mode D'emploi

02 Yacht Boy 80, GB
10
19.08.2003 14:52 Uhr
SETTINGS
___________________________________________________
Deleting preset stations
1 Enter the preset station using the numerical buttons »
– Display: the frequency and the preset number, for example »
Press »MEMO
2 AM/PM«.
– Display: The selected preset station flashes.
Press »C M.
3 DEL«.
– The selected preset station is deleted.

Setting the alarm time

The alarm time is always set in the time shown on the display.
You can set the alarm as a signal tone, a radio station, or both.
Press »ALARM
1
with the device switched off.
– Display: the alarm time most recently set, »
Note:
If the radio is switched off, press »DISPLAY« to switch the display to
the clock, and start at step 1.
Enter the alarm time using the numerical buttons »
2
Press » FREQ./CLOCK« to confirm the entry.
3
– Display: the alarm time you entered, »
– The device switches on at the set time with the signal tone or the radio
station most recently selected.
Seite 30
« (signal tone) or »ALARM
« or »
1 ... 9«.
«.
« (radio station)
« or » « flash.
1 ... 0«.
« stay lit.