Sangean ProTravel PT80 Mode D'emploi page 9

02 Yacht Boy 80, GB
8
19.08.2003 14:52 Uhr
SETTINGS
___________________________________________________
Setting and storing radio stations
There are various ways to set radio stations and store them at preset positions.
1 Press »ON/OFF
– You will hear the radio station last selected.
Press »BAND« to select the frequency band.
2
Tuning radio stations directly
Press »
1 FREQ./CLOCK«.
– Display: »– –.– –«, e.g. »
2 Enter the frequency using the numerical buttons
for example 1, 0, 0, 6 for »100.60«.
Press » FREQ./CLOCK« to confirm the entry.
3
– Display: the frequency you entered, for example »100.60«.
– You will hear the selected radio station.
Tuning radio stations manually (1)
Use the »TUNING
1
– Display: the frequency in 100 or 200 kHz increments (FM), in 9 or
10 kHz increments (MW), in 3 kHz increments (LW) or in 5 kHz incre-
ments (SW).
If you want, you can fine tune to the station by briefly pushing in and
2
turning the »TUNING
– Display: The frequency changes in 50 kHz increments (FM) or 1 kHz
increments (MW, LW and SW).
To return to the original mode (for example 100 kHz increments in the
3
FM band) push in the
Tuning radio stations manually (2)
1 Keep pressing » « or » « until you reach the frequency you want.
– Display: the frequency changes in increments
or
Hold down » « or » « until the frequency changes to a rapid run-
through.
– Display: the automatic search stops at the next station with a strong
signal.
Saving radio stations on preset positions
You can store up to 45 radio stations, including 18 on two memory levels
on short wave, and nine each on FM, MW and LW.
1 Select the frequency band and the radio station.
Seite 28
SLEEP« to switch on the device.
« and »MHz« flash.
FM
FINE« dial to tune to the station you want.
FINE« dial.
»TUNING FINE« dial again.
»1 ... 0« in four digits,