Remote Control - EdilKamin PELLET-BLOK Installation, Usage Et Maintenance

REMOTE CONTROL

This controls all the functions.
Key to buttons and display:
: to turn off and on (to go from remote control on stand-by to remote control on)
+/-
: to increase/decrease the various regulations
A : to select Automatic function
M : to select Manual function and access the control and programming menus
The display also shows other useful information in addition to the icons described above.
- Stand-by position:
shows room temperature (20°C), kg of pellets (15 kg) remaining in tank and current time (15.33)
- Manual work phase:
shows power set (Power 1), room temperature (20°C), kg of pellets and autonomy remaining (15 kg 21 hrs)
- Automatic work phase:
shows temperature set (Set 22°C), room temperature (20°C), kg of pellets and autonomy remaining (15 kg 21 hrs).
DO NOT PRESS THE BUTTON MORE THAN ONCE
Note: If the radio control is not used for a few seconds, the display will go dark as it has moved into the power saving
function. The display can be reactivated by pressing any button.
In case of breakage or loss of the radio control, power on/off and setting the operating power can be done using an emer-
gency button located inside the fireplace.
INSTRUCTIONS FOR USE
- icon flashing: remote control searching for network
- icon fixed: remote control with connection enabled
flat battery
(3 mini alkaline batteries type AAA)
keypad locked
(press "A" and "M" in parallel for a few seconds to lock
or unlock the keypad)
programming enabled
alphanumeric display consisting
of 16 figures arranged in two lines
of 8 figures
- icon flashing: Fireplace turning on
- icon fixed: Fireplace working
manual adjustment function
(display shows working power)
automatic function
(display shows temperature)
.
30