Gaymar Medi-Therm III Mode D'emploi page 7

Medi-Therm III
®
SELECT MODE
®
Figure 2—Medi-Therm III Control Panel
BLANKET CONTROL—
Adjust SET POINT to control
water temperature.
(4°C to 41°C)
PATIENT CONTROL—
Connect patient probe, then
adjust SET POINT to control
patient temperature.
(30°C to 39°C)
CONTROL OPTION—
Cooling/Warming adjusted to
RAPID rate.
Cooling/Warming adjusted to
MODERATE rate.
Cooling/Warming adjusted to
GRADUAL rate.
MONITOR ONLY—
Connect patient probe,
then use to monitor patient
temperature. No therapy is
provided.
Operator Control Panel
TEMPERATURE
WATER TEMPERATURE—
This display lights when either PATIENT
CONTROL or BLANKET CONTROL is
selected.
PATIENT TEMPERATURE—
As measured by the patient probe.
This display lights whenever a patient
probe is plugged in.
SET POINT CHANGE—
Press the "q" or "p" button to select
machine set point. When selecting a
temperature outside the normothermic
range (36°C to 38°C), an audible alarm
will chime. Press and hold the "q" or
"p" button until the chime stops to
access the extended temperature range.
PATIENT PROBE JACK—
Insert only a Gaymar probe or an
equivalent YSI 400 series probe
approved fore use with medical devices.
[located on front of machine]
®
5