Programming Codes And Auto-Scan; Saving Settings; Programming Mode Faq - Motorola CP110 Série Guide De L'utilisateur

Programming Codes and Auto-Scan

Each time your radio signals and beeps the
current setting you can change this setting by
either increasing it by short pressing SB1 or
decreasing it by short pressing SB2. The radio
will then signal the new setting it has been
programmed.

Saving Settings

If you are satisfied with the setting, you can
either:
• short press PTT to continue programming,
• long press PTT to save and return to 'Idle'
Programming Mode, or
• long press the PTT button twice to exit 'Idle'
Programming Mode and return to the normal
radio operation.
Note:
• If you do not wish to save the value you just
programmed, turn radio OFF or change channel
using the channel knob.
38
English
• If you 'roll-over' to the beginning at Idle
Programming Mode you will hear a 'chirp' and the
LED Indicator will start blinking green again. All
values that were changed will be automatically
saved.

Programming Mode FAQ

1. I got distracted while programming and
forgot which digit I was programming.
What should I do?
Return to 'Idle' Programming Mode and start
over, as you will not be able to return to the
Programming Mode (the radio does not provide
further way to let you know the specific stage
you are at when programming). Therefore
you can:
• Long press the PTT button. The radio will return
to the 'Idle' Programming Mode or,
• Turn OFF the radio and enter Programming
Mode again (see instructions in the beginning of
this section).