Setting Vox Sensitivity; Microphone Gain; Battery Save; Reset To Factory Defaults - Motorola CP110 Série Guide De L'utilisateur

Setting VOX Sensitivity

The sensitivity of the radio's accessory or
microphone can be adjusted to suit different
operating environments. VOX sensitivity can
be programmed via the CPS.
Default value is OFF (level 0). If you want to
use the VOX feature, VOX level should be set
at a level different from 0.
• 1 = Low sensitivity
• 2 = Medium sensitivity
• 3 = High sensitivity

Microphone Gain

The sensitivity of the microphone can be
adjusted to fit different users or operating
environments.
This feature can be adjusted only through the
CPS. Microphone default setting is set to
level 2 (medium gain).
32
English

Battery Save

Battery Save feature extends battery life as
your radio goes into 'Idle' state. To enable/
disable, press SB1 and SB2 buttons
simultaneously for 2 or 3 seconds while
powering up the radio, you will hear a quick
series of beeps. To have a slightly better attack
time, set Battery Save feature to OFF so that
the radio is always ready to transmit or receive
without any delays.
Note: Battery Save feature default is set to ON.

Reset to Factory Defaults

Resets radio features to the original factory
default settings. To do so, press PTT, SB2 and
SB1 simultaneously while turning ON the radio
until you hear a high tone chirp.
End of Transmission Tone (Roger Beep
Tone)
To enable/disable, short press the SB1 button
while turning ON the radio.
Note: The default setting is OFF for this feature.