Programming Features; Programming Mode; Learning To Read The Values The Radio Signals You - Motorola CP110 Série Guide De L'utilisateur

PROGRAMMING
FEATURES
To easily program all the features in your radio,
it is recommended to use the CPS
Programming Cable and CPS software.
CPS software download is available by visiting
the following website:
https://businessonline.motorola.com

PROGRAMMING MODE

Programming Mode is a special radio mode to
program basic radio's features by using the
radio's panel.
When the radio is set to Programming Mode,
you are able to read and modify three features:
• Codes (CTCSS/DPL) and,
• Auto-Scan.
Frequencies can be modified via the CPS only.
You can select a frequency for each channel.
The Interference Eliminator Code (CTCSS/DPL)
helps minimize interference by providing you
with a choice of code combinations that filter out
static, noise, and unwanted messages.
The Auto-Scan feature allows you to set a
particular channel to automatically enable Scan
each time you switch to that channel.
Learning to Read the Values the Radio
Signals You
As the non-display model does not have a
display to show the values that are being
programmed, the radio will communicate this
information using beeps and LED indications.
The radio's LEDs will blink two colors:
• Orange to signal '0' and,
• Red for other values from '1' to '9'.
Short and long red blinks differentiate the
specific number the radio is signaling you.
Please refer to "Programming Mode: Reading
the Values" table on page 35.
33
English