Power Connections; Power Source; Extension Cords - Delta 36-6022 Guide D'utilisation

POWER SOURCE

This saw is equipped with a 15-amp motor for use with
a 120-volt, 60-HZ alternating current. See instructions
below regarding proper connections for your saw.
For voltage, the wiring in a shop is as important as the
motor's rating. A line intended only for lights may not be
able to properly carry the current needed for a power tool
motor; wire that is heavy enough for a short distance may
be too light for a greater distance; and a line that can
support one power tool may not be able to support two
or three.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.

EXTENSION CORDS

Never use a damaged extension cord.
Check extension cords before each use.
If damaged, replace immediately. Touching the damaged
area could case electrical shock resulting in serious injury.
Keep the extension cord clear of the
work area. Position the cord so it will not
get caught on lumber, tools or other obstructions.
• Use proper extension cords. When using an
extension cord, be sure to use one heavy enough to
carry the current machine. An undersized cord will
cause a drop in line voltage, resulting in loss of power
and overheating. The table shows the maximum
gauge to use depending on the cord length. If in
doubt, use the next heavier gauge. The smaller the
gauge number, the heavier the cord. Only round,
jacketed cords listed by Underwriter's Laboratories
(UL) should be used.
• When working with the tool outdoors, use an
extension cord designed for outside use.

POWER CONNECTIONS

8
A separate electrical circuit should be used for your
machines. This circuit should not be less than #12 wire
and should be protected with a 20-amp time lag fuse.
Before connecting the machine to the power line, make
sure the switch is in the "OFF" position and be sure that
the electric current is of the same characteristics as
indicated on the machine. A substantial voltage drop will
cause a loss of power and overheat the motor. It may
also damage the machine.
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC
MACHINES
AMPERE VOLTS TOTAL LENGTH
RATING OF CORD IN
0-6 120 Up to 25
0-6 120
0-6 120 50-100
0-6 120 100-150
6-10 120 Up to 25
6-10 120
6-10 120 50-100
6-10 120 100-150
10-12 120 Up to 25
10-12 120
10-12 120 50-100
10-12 120 100-150
12-16 120 Up to 25
12-16 120
12-16 120
GAUGE OF
EXTENSION CORD
FEET
18 AWG
25-50 16 AWG
16 AWG
14 AWG
18 AWG
25-50 16 AWG
14 AWG
12 AWG
16 AWG
25-50 16 AWG
14 AWG
12 AWG
14 AWG
25-50 12 AWG
GREATER THAN 50 FEET NOT
RECOMMENDED