Proposition 65 Warning; Power Connections; Power Source - Delta 36-6013 Manuel D'utilisation

Dust created by power sanding, sawing, grinding, drilling, and other construction activities may contain chemicals known to the
state of California to cause cancer, birth defects or other reproductive harm. Some examples are:
– Lead from lead-based paints
– Crystalline silica from bricks and cement and other masonry products
– Asbestos dust
– Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies depending on how often you do this type of work. To reduce your exposure to these
chemicals: work in a well-ventilated area and work with approved safety equipment, such as dust masks that are specifically
designed to filter out microscopic particles.
Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap and water.
If you have any questions or concerns relative to the use of your tool or the contents of this manual, stop using the tool and call
DELTA Customer Care at 1-800-223-7278.
®

POWER SOURCE

This saw is equipped with a 15-amp motor for use with a
120-volt, 60-HZ alternating current. See instructions below
regarding proper connections for your saw as wired.
For voltage, the wiring in a shop is as important as the motor's
rating. A line intended only for lights may not be able to
properly carry the current needed for a power tool motor; wire
that is heavy enough for a short distance may be too light for
a greater distance; and a line that can support one power tool
may not be able to support two or three. A separate electrical
circuit should be used for your machines. This circuit should
not be less than #12 wire and should be protected with a
20-amp time lag fuse. If an extension cord is used, use only
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP
LOCATIONS.

PROPOSITION 65 WARNING:

SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
If tool is loaned to someone, also loan them these instructions.

POWER CONNECTIONS

3-wire extension cords which have 3-prong grounding-type
plugs and matching receptacle which will accept the machine's
plug. Before connecting the machine to the power line, make
sure the switch (s) is in the "OFF" position and be sure that
the electric current is of the same characteristics as indicated
on the machine. A substantial voltage drop will cause a loss
of power and overheat the motor. It may also damage the
machine.
7