Contents Of Hardware Bags; Assembly - Delta 36-6013 Manuel D'utilisation

CONTENTS OF HARDWARE BAGS

hh. 4mm Allen Wrench (1)
jj. Wheel Handle Shoulder Screw (1)
kk. Height Adjustment Wheel Knob
• Do not lift saw without help. Hold it close to your body
while lifting. Keep knees bent and lift with you legs, not
your back.
• Stand assembly is an integral and necessary part of the
support structure for this saw.
• Do not modify saw, or create accessories not recommended
for use with this saw.
SAW BLADE GUARD, ANTI-KICKBACK PAWLS AND RIVING KNIFE

ASSEMBLY

Your table saw is equipped with a blade guard, anti-kickback
pawls and riving knife assembly that covers the blade and
reduces the possibility of accidental blade contact. The riving
knife is a flat plate that fits into the cut made by the saw
blade and effectively fights kickback by lessening the tendency
of the blade to bind in the cut. Two anti-kickback pawls are
located on the sides of the riving knife that allow the wood to
pass through the blade in the cutting direction but reduce the
possibility of the material being thrown backwards toward the
operator. The blade guard and anti-kickback pawls can only be
used when making through cuts that sever the wood. When
making rabbets and other non-through cuts, the blade guard
and anti-kickback pawls must be removed and riving knife
lowered to the non-through cut position marked on the riving
UNPACKING
ASSEMBLY
• Make sure power switch is in "OFF" position before
connecting to power supply. Do not connect ti power
supply until assembly is complete.
• Avoid contact with blade teeth. Keep blade stored or
lowered when possible.
knife.
Use all components of the guarding system (blade guard
assembly, riving knife and anti-kickback pawls) for every
operation for which they can be used including all through-
cutting. If you elect not to use any of these components for
a particular application, exercise additional caution regarding
control of the workpiece, the use of push sticks, the position
of your hands relative to the blade, the use of safety glasses,
the means to avoid kickback and all other warnings contained
in this manual and on the saw itself. Replace the guarding
systems as soon as you return to through-cutting operations.
Keep the guard assembly in working order.
10