Basic Steps In Making Bread - WestBend 41410 Mode D'emploi

Always clean your new appliance thoroughly before using. Refer to "Cleaning
Your Breadmaker" section.
1. Insert the bread pan; place the bread pan in the center of the baking chamber.
When the bread pan is pressed lightly in the center, the fixing device locks into
place. To remove the bread pan, pull with medium force on the bread pan carrying
handle. CAUTION: The handle is hot after baking. Use oven mitts or hot pads when
removing a hot bread pan.
2. Position the knead blades on to the shafts in the bottom of the bread pan,
matching the hub shapes with the shaft shapes. You may need to twist the bars
slightly for the knead blades to drop in place. Make sure the knead blades are
pushed down on the shaft all the way. The knead blade is all the way down when
the top of the shaft is flush with the top of the knead bar.
3. Add ingredients to the bread pan in the order listed in the recipe; liquids first, then
the butter or margarine, next the dry ingredients and finally the yeast. For best
results level the dry ingredients before adding the yeast. Note: Ingredients and
measuring are the key to successful breadmaking. We highly recommend
reading the "Know Your Ingredients and Other Helpful Hints" section of this
manual before making bread.
4. Plug the breadmaker cord into a 120 volt, AC electrical outlet ONLY.
5. Use the "MENU" button to select the desired program menu. (see pg. 5)
6. Use the "LOAF" button to select the desired loaf size.
7. Use the "COLOR" button to select the desired crust darkness.
8. If desired, use the "TIME +" and "TIME -" buttons to set the elapsed time for when
the program is to be completed (see pg. 4).
9. Press the "START/STOP" button to begin the program. After the breadmaker has
been turned on, the programmed setting cannot be changed without canceling
the program. To change the setting, hold the "START/STOP" button down until
the alert sounds; program the control as desired and turn back on.
• A small amount of smoke and/or odor may occur upon heating due to the
release of manufacturing oils - this is normal.
Some minor expansion/contraction sounds may occur during heating and
•
cooling - this is normal.
10. When the bread is done, an alert will sound. Turn the breadmaker off by holding
the "START/STOP" button down until the alert sounds. Unplug the cord from the
electrical outlet. If the breadmaker is not turned off after the cycle is complete, the
breadmaker will automatically go into a one hour "Keep Warm" mode. If the
machine is not turned off after the end of the "Keep Warm" period, the machine
will turn itself off.
11. Remove the bread pan. CAUTION: The handle is hot after baking. Use oven
mitts or hot pads when removing a hot bread pan.
12. Invert the bread pan and shake gently until the loaf falls out. Place the bread on a
rack to cool 15 to 20 minutes. The knead blade will normally stay in the bread
pan when the bread is removed, but may on occasion slide out in the bread.
CAUTION: The knead blade is very hot, remove with care. If making another loaf
of bread right away, be sure the machine is turned off, unplugged, and allowed to
cool for 15 to 20 minutes with the cover open.
English - 6
B S
ASIC TEPS IN
M B
AKING READ