Changing The Radio Channel - Auriol AFW 2 A1 Mode D'emploi

Changing the radio channel

Changing the radio channel on outdoor sensor
You can select between 3 radio channels . Channel 1 is preset .
♦ Open the battery compartment a on the rear of the device
by removing the battery compartment cover s .
♦ Select a radio channel by pushing the channel selector p
to CH1, CH2 or CH3 .
Press and hold the – /CH button 6 until the reception
♦
signal
Press the TX button o to manually initiate the outdoor sensor
♦
radio signal . If reception is successful, the temperature and
moisture on the outdoor temperature sensor 3 will now
be displayed on the new radio channel .
♦ Close the battery compartment a again .
Changing the radio channel display on the weather
station
If the weather station is receiving the outdoor sensor radio signal,
it will automatically display the appropriate channel .
However, you can also manually set the display of various radio
channels .
Press the – /CH button 6 repeatedly to switch between the
♦
displays CH1 (only display channel 1), CH2 (only display
channel 2), CH3 (only display channel 3) and
all channels alternately in a loop) .
AFW 2 A1
flashes on the outdoor temperature panel 3 .
(display
GB │ IE │
59 ■