Snooze Function; Nap Timer Function; Display Maximum/Minimum Temperature/Humidity - Auriol AFW 2 A1 Mode D'emploi

Snooze function

While the alarm is going off, press the SNOOZE/LIGHT
♦
button 9 to activate the snooze function . The alarm signal is
interrupted for around 5 minutes . The display for the snooze
function ( ) and the alarm symbol

NAP timer function

♦ Press and hold the NAP button q button for around 3 sec-
onds to set the duration of the nap timer . The currently set
nap time will flash on the time panel 5 .
Press the – /CH button 6 or the +/MEM button 7 to set
♦
the maximum value (from 5 minutes up to a maximum of
2 hours in 5-minute stages) .
♦ Press the NAP button q to confirm your entry and to
start the nap timer . The set time starts counting down . The
alarm go off for around 2 minutes once the time has been
counted down .
♦ Press any button to deactivate the nap timer .
Display maximum/minimum temperature/
humidity
Once the power supply and the connection to the outdoor sensor
have been established, the maximum and minimum values for
temperature and humidity are automatically recorded and saved
by the weather station .
♦ In basic mode, press the +/MEM button 7 once .
The symbol is shown next to the humidity display on
both temperature panels, and the highest measured value
for indoors and outdoors is displayed .
AFW 2 A1
flash on the display .
GB │ IE │
57 ■