Starting The Outdoor Sensor / Changing Batteries; Starting The Main Station / Changing Batteries - Auriol HG02832A Instructions D'utilisation Et Consignes De Sécurité

Starting the outdoor sensor /
changing batteries
Open the battery compartment
sensor by sliding the battery cover
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
17
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.

Starting the main station / changing batteries

Open the battery cover
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The display
1
display elements.
Alternatively, first remove the batteries from the battery compartment.
Plug the low voltage plug of the mains adapter
adapter socket
31
into an easily accessible outlet. The display will permanently light
up and run a brief check of all display elements.
The outdoor temperature field
reception symbol , indicating the main station is searching for
the signal from the outdoor sensor.
at the front of the outdoor sensor will briefly
at the back of the main station by
5
will briefly light up and run a brief check of all
in the main station and plug the mains adapter
23
on the back of the outdoor
21
in the direction of the arrow.
18
30
will show an animation of the
.
21
.
16
into the mains
GB/IE 39