Electrical Connection - Dimplex LAW 9IMR Instructions D'installation Et D'utilisation

6

Electrical connection

6.1 Supply voltage / fuse protection
RCD-Type
6.2 Control voltage / fuse protection
6.3 Degree of protection according to EN 60 529 indoors/outdoors
6.4 Starting current limiter
6.5 Rotary field monitoring
6.6 Starting current
6.7 Nominal power consumption at A7/ W35 /
5 10
max. consumption
Nominal current at A7/W35 / cos 
6.8
6.9 Nominal power consumption at A2/ W35
6.10 Power consumption of compressor protection
(per compressor)
6.11 Power consumption of fan
7 Complies with the European safety regulations
8 Additional model features
8.1 Type of defrosting
8.2 Condensate tray frost protection /
water in device is protected from freezing
8.3 Max. operating overpressure (heat source/heat sink)
9 Heat output / coefficient of performance (COP)
9.1 Heat output / coefficient of performance (COP)
at A-7 / W35
at A2 / W35
at A7 / W35
at A7 / W45
at A10 / W35
9.2 Cooling capacity / coefficient of performance (COP)
at A27 / W7
at A27 / W18
at A35 / W7
at A35 / W18
1. The specified sound levels apply if the supporting feet (available as an option) are not used. If the supporting feet are used, the level can increase by up to 3 dB (A).
2. The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation with a flow temperature of 35°C
The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.
3. Please note that additional space is required for pipe connections, operation and maintenance.
4. Delivery state 6 kW
5. This information shows the size and performance of the system in accordance with EN 14511. For economical and energy-related considerations, the bivalence point and control
must be taken into account. These figures are only achieved with clean heat exchangers. Instructions for care, commissioning and operation can be found in the relevant sections
of the installation and operation instructions. The specified values have the following meaning, e.g. A7 / W35: Heat source temperature 7 °C and heating water flow temperature
35 °C.
6. Max. intake incl. pipe heating and immersion heater (state of supply)
7. See CE declaration of conformity
8. The heat circulating pump and the heat pump controller must always be ready for operation.
9. COP-optimised operation
10.Maximum heating/cooling output
www.dimplex.de
Compressor
Heating cartridge
Compressor + heating cartridge
A
kW
A / --
10
W
W
8
bar
5
9
kW / ---
10
kW / ---
9
kW / ---
10
kW / ---
9
kW / ---
10
kW / ---
9
kW / ---
10
kW / ---
9
kW / ---
10
kW / ---
10
kW / ---
10
kW / ---
10
kW / ---
10
kW / ---
452162.66.04 · FD 9309
LAW 9IMR - LAW 14ITR
1~/N/PE 230 V (50 Hz) / C25 A
1~/N/PE 230 V (50 Hz) / C35 A
3~/N/PE 400 V (50 Hz) / C32 A
B
1~/N/PE 230 V (50 Hz) / C13 A
IP 20 / IP X4
Inverter
Yes
1,2
6
2,11 / 10,91
9,27 / 0,99
1,91
--
124
7
Reverse circulation
No / Yes
3,0
EN 14511
6,7 / 2,8
6,7 / 2,8
5,3 / 3,6
6,2 / 3,2
5,6 / 4,8
9,0 / 4,3
5,4 / 3,4
8,3 / 3,3
6,0 / 5,1
9,6 / 4,5
6,5 / 3,3
8,7 / 4,2
6,2 / 2,6
9,0 / 3,4
3~/N/PE 400 V (50 Hz) / C32 A
B
1~/N/PE 230 V (50 Hz) / C13 A
IP 20 / IP X4
Inverter
Yes
1,3
6
3,39 / 13,78
4,94 / 0,99
3,50
--
248
7
Reverse circulation
Yes/ Yes
3,0
EN 14511
13,9 / 2,9
13,9 / 2,9
10,5 / 3,6
11,0 / 3,2
10,6 / 4,1
14,7 / 4,3
9,8 / 3,7
13,9 / 3,3
11,3 / 4,5
15,7 / 4,3
12,9 / 3,0
17,1 / 3,7
12,3 / 2,5
15,5 / 3,3
EN-19