Storing The Unit; Protecting The Environment - Ego Power+ EA0800 Manuel De L'opérateur

TRANSMISSION GEARS LUBRICATION
The transmission gears in the gear case need be
lubricated periodically with gear grease. Check the gear
case grease level about every 50 hours of operation by
removing the sealing screw on the side of the case.
If no grease can be seen on the sides of the gear, follow
the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gears.
1. Position the edger upright so that the sealing screw
is facing upwards (Fig. N).
2. Use the multi-functional wrench provided to loosen
and remove the sealing screw. Use a grease syringe
(not included) to inject some grease into the screw
hole; do not exceed 3/4 capacity.
3. Tighten the sealing screw after injection.

STORING THE UNIT

◾
Remove the battery pack from the edger
◾
Clean the tool thoroughly before storing it.
◾
If the edger attachment is removed from the power head
and stored separately, fit the end cap on the attachment
shaft to avoid dirt getting into the coupler.
◾
Store the unit in a dry, well-ventilated area, locked-up or
up high, out of the reach of children. Do not store the unit
on or adjacent to fertilizers, gasoline, or other chemicals.

Protecting the environment

Do not dispose of electrical equipment,
battery charger and batteries/
rechargeable batteries into household
waste!
According to the European law
2012/19/EU, electrical and electronic
equipment that is no longer usable, and
according to the European law
2006/66/EC, defective or used battery
packs/batteries, must be collected
separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get
into the food chain, damaging your health
and well-being.
EDGER ATTACHMENT — EA0800
EN
11