Assembling And Installing; Installation; How To Open The Housing; Camera Installation - Videotec HOV Hi-PoE Manuel D'instructions

6 Assembling and
installing
Only specialised personnel should be
h
allowed to assemble and install the device.

6.1 Installation

6.1.1 How to open the housing

To open the housing, loosen the 2 screws on the side,
turn the cover and the upper half of the body about
the opening hinge axis.
Fig. 01
In this way there will be easy access to the inside of
the housing.

6.1.2 Camera installation

This section describes how to install the camera
inside the housing. It should be remembered that the
power supply can be taken from the circuit supplied
after making sure it is correct one.
Open the housing as described before.
Extract the internal support slide (01) by partially
loosening the fastening screws (02).
Move the slide by sliding it until the holes coincide
with the slide locking screws. Fasten the camera with
the 1/4" screw.
If necessary, use the supplied spacers to correctly
position the camera and optics (03).
01
02
Fig. 02
Reposition the internal slide by tightening the
previously loosened screws.
03

6.1.2.1 RJ45 connection

Fit the gasket (01) to the cable gland M20 (02).
Fasten the cable gland to the bottom of the housing
(03) using the M20 nut (04) with a torque wrench
setting of 7Nm.
Pass the cable with connector RJ45 (05) through the
upper part of M20 cable gland (06).
04
01
03
Fig. 03
Choose the gasket and then put it on the cable.
Fig. 04 Diameter of cable from 3.5mm a 5.5mm.
Fig. 05
Diameter of cable from 5.5 to 7.5 mm.
Fig. 06
02
05
06
5