Checks To Be Made At The End Of The Season; Notes For Disposal; Frequent Troubleshooting; General Phenomena - Tekno Point WN-09 Manuel D'utilisation

ENGLISH

Checks to be made at the end of the season

Disconnect the power supply through the dedicated electrical switch or by removing the plug from the
socket.
Clean the filter and the panel of the indoor unit.

Notes for disposal

Most of the packaging materials are recyclable. Please dispose of them according to the disposal methods
in your country.
If you wish to dispose of the air conditioning system please contact qualified personnel for the removal of
the plant and then contact the ' local authority of management of waste for proper disposal.
IT IS MANDATORY TO CARRY OUT ANNUAL MAINTENANCE PROVIDED FOR BY THE REGULATIONS IN FORCE,
WITH THE USE OF A QUALIFIED SPECIALIZED TECHNICIAN ..

Frequent troubleshooting

General phenomena

Please consult the following table before requesting assistance. If the fault persists, contact the supplier or
qualified service center.
Phenomenon
The indoor unit does not receive
the signal from the remote
control
No air comes out of the UI
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
COMMERCIALE@TEKNOPOINT.COM –
Verifications
Have there been voltage
fluctuations?
Is the remote control beyond the
maximum distance range?
Are there any obstacles between
the remote control and the UI?
Is the remote control correctly
aimed at the infrared receiver?
Is the display irregular?
The remote seems to be properly
positioned, but the UI is not
receiving the signal
Are there fluorescent lamps?
Are the air supply or intake
blocked?
In heating mode, has the set
temperature been reached?
MUI_WINE_Ita_Eng_Fra_Deu_TP/Rev.00/Data 28.09.2020
Solutions
Remove voltage from the
appliance and supply it after
waiting for at least 180 sec
The maximum distance is 8 m
Remove any obstacles
Replace the remote control and
try again
Check the batteries, replace if
necessary
Contact the supplier
Move the remote control closer
to the UI. Turn off the
fluorescent lamps and try again
Remove any obstacles
After reaching the set
temperature, the IU stops the
fan
WWW.TEKNOPOINT.COM
66