Tekno Point WN-09 Manuel D'utilisation page 63

3. Unsheat the electrical cables and connect the power and communication cables to the correct
terminal respecting the color. Tighten the screw and then secure the cable with the appropriate
cable clamp on the terminal board.
4. Replace the wiring compartment cover and then secure or tighten the screw.
5. Close the front panel
Note:
All connections between indoor unit and outdoor unit must be made by qualified personnel.
If the power cable is not long enough, replace it with one of adequate length.
For plug-in air conditioners, the plug should be connected only after installation is complete.
For air conditioners without power supply by means of a plug, a switch must be provided to disconnect the
system's power supply.
Pipe cover
5. Once completed the junction of the refrigerant pipes cover the pipes, the shortcuts to electrical
cables of power and communication and d having connected the drain tube fix everything with the
band.
6. Reserve an adequate additional lenght of pipe drainage and power cord and communication to
complete the installation. After you fixed for a few centimeters of the tubing and cables between,
separating the drain hose and the power cord (as shown in the figure).
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
COMMERCIALE@TEKNOPOINT.COM –
MUI_WINE_Ita_Eng_Fra_Deu_TP/Rev.00/Data 28.09.2020
Indoor and outdoor power cord
Gas pipe
Tape
WWW.TEKNOPOINT.COM
61
Nastro
Liquid pipe
Drain hose
ENGLISH