Display; Instruction For Use; Battery Installation - Tekno Point WN-09 Manuel D'utilisation

ENGLISH

Display

Instruction for use

Battery installation

- Press on the back of the remote control as shown in the figure, then remove the battery
compartment cover following the direction of the arrows
- Install two AAA batteries, making sure that the pole positions are respected
- Reinsert the battery compartment cover
Operation
- After connecting the air conditioner to the power, press
- Press the MODE button to select the desired mode: Auto, Cooling, Dry, Fan, Heating.
- Press the "+" and "-" keys to set the desired temperature.
- Press the FAN key to set the desired fan speed.
- to press or
Note:
- During use, point the remote control at the receiver window of the air conditioner.
- The distance between the sender and the receiver should not be greater than 8 meters, and there
should be no obstacles between the two.
- The signal may be disturbed if there are fluorescent lamps or wireless telephones in the room; in
this case, move the remote control closer to the air conditioner.
- When the remote control is not used for a long time, remove the batteries.
- If the remote control display becomes blurred or does not work, replace the batteries
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
COMMERCIALE@TEKNOPOINT.COM –
WIFI
Temperature indicator
Power on indicator
to select the angle of the flap
MUI_WINE_Ita_Eng_Fra_Deu_TP/Rev.00/Data 28.09.2020
to turn on the air conditioner.
WWW.TEKNOPOINT.COM
46