Symbols On The Device; Device Description; Initial Startup - Kärcher T7 Plus T-Racer Surface Cleane Mode D'emploi

Note
● Be sure to always adhere to
the safety instructions for your
high-pressure cleaner and the
locally applicable regulations
and directives.

Symbols on the device

DANGER
Risk of injury! Never reach under the
edge of the T-Racer during operation
Cleaning type: Surface cleaner
Cleaning type: Edge and corner cleaning
Cleaning type: Rinsing function
HARD For durable surfaces, e.g. tiles, concrete,
stone
SOFT For sensitive surfaces, e.g. wood

Device description

For the illustrations, refer to the graphics page
Illustration A
Extension tube
1
Rotor arm height adjustment
2
Casing
3
Bayonet connector with union nut
4
Handle
5
Surface cleaning foot button
6
Edge and corner cleaning foot button
7
High-pressure nozzle
8
Rotor arm
9
Front high-pressure nozzle
10
Skids
11
Rinsing nozzle
12
Rinsing function foot button
13
Extension tube installation
Note
Ensure that the device components are tightly connect-
ed on installation.
Illustration B
1. Plug the bayonet into the mounting.
2. Turn the extension until it latches into place.
3. Tighten the union nut.
Repeat the procedure for all further extension tubes.
Selection of the high-pressure nozzles
Using the appropriate high-pressure nozzles is a pre-
requisite for fault-free operation.
Note
These are to be selected according to the flow rate (l/
min). Information on the flow rate is provided in the op-
erating instructions or on the type plate of the high-pres-
sure cleaner.
Note
The yellow high-pressure nozzles are already fitted.
Flow rate l/min (l/
h)
5.8 (348) - 7.5
(450)
Greater than 7.5
(450)
Note
The extension tubes can be used with all Kärcher ac-
cessories.
Note
For optimum cleaning results, do not operate the high-
pressure cleaner in the Eco mode.
Remove coarse dirt from the surface to be cleaned (e.g.
by sweeping) before using the device to avoid damage
to the T-Racer.
ATTENTION
Damage to the rotor arm
The rotor arm can be damaged if it hits edges and cor-
ners.
Do not move the device over free-standing corners and
edges.
Illustration C
Note
 The T-Racer is not suitable for scraping or scrub-
bing.
 Test the device on an inconspicuous area before us-
ing on sensitive surfaces, e.g. wood.
 Do not allow it to remain in one area, but keep it in
motion.
1. Attach the T-Racer to the high-pressure gun using
the extension tube.
Illustration B
a Press the extension tube onto the bayonet con-
nector of the high-pressure gun.
b Turn the extension tube by 90° until it latches into
place.
c If necessary, repeat the procedure for further
connections.
2. Adjust the rotor arm height adjustment. according to
the surface to be cleaned.
3. Unlock the lever of the trigger gun.
4. Pull the lever of the trigger gun.
The device switches on.
5. Clean the floor surface by guiding the T-Racer over
the floor surface without exerting excessive pres-
sure.
English

Initial startup

High pressure Colour of the
class (e.g.) high-pressure
nozzles
K4 - K5 Grey
K6 - K7 Yellow
Operation
Cleaning floors
7